How To Remove Kitchen Drawers

Download Article

Download Article

Every now and then, certain cleaning and moving tasks may require you to manually remove the drawers from a cabinet, dresser, or similar slice of furniture. Removing drawers is a cinch in nearly cases, but the process tin can vary a chip depending on the type of drawer you're working with. Most woods-glide and free-rolling drawers volition come straight out with a little bit of force or a tilt at the right bending. For drawers with stopping mechanisms like stabilizer screws or anti-tip cables, you'll need to remove the screws holding the drawer in place earlier you tin finish pulling it out.

1. one

   Pull the drawer out as far as information technology will go. Stand in front end of the piece of furniture, take hold of the handle or knob on the front panel, and begin sliding the drawer out until it stops moving. If the drawer doesn't have a stopper, information technology should come correct out. If you encounter resistance, yous'll need to move the drawer effectually a little in guild to work it gratis.^[1]

   • Almost drawers contain some type of stopping machinery designed to keep them from falling out accidentally. In free-rolling drawers, the stopper is typically a small raised lip on the front side of the interior runway.
   • Be certain to keep plenty infinite between you and the front of the drawer to let information technology to extend all the way out.^[2]

   Tip: Woods-Glide draws can sometimes seem to stick a niggling, even if they're non fitted with stoppers. Before you start searching for obstructions, try giving the drawer a expert tug to run into if that gets information technology past its sticking point.^[three]

2. ii

   Tilt the front of the drawer downwards. Push down on the sides of the drawer and then that the back end lifts slightly. This will cause the wheels or lip on the back border to raise up college than the stopper at the front end of the track, making information technology possible to pull the drawer out the rest of the way.^{[4] [five]}

   • You may demand to stone or jostle the drawer to help free the wheels from the track. Be conscientious not to get too rough with it, though, or you could damage it or its attached hardware.

   Advert

3. three

   Finish pulling the drawer direct out. One time the wheels or back edge are by the stopper, all you have to do is slide the drawer off of the track and out of the opening in the piece of furniture. Set the drawer aside on a flat, stable surface and repeat the process for any additional drawers you wish to remove.^{[six] [vii]}

   • If you're still having trouble getting the drawer out, at that place'due south a chance that it may be equipped with another blazon of stopping machinery, such as levers or stabilizer screws.

   Advertisement

1. 1

   Open up the drawer and identify the rails levers forth the outer walls. Yous should see a lever on each side of the drawer, right around the center of the runway. These levers may either be straight or slightly curved. Their job is to forestall the drawer from existence removed until they're disengaged.^{[8] [9]}

   • Be careful not to become your fingers defenseless in the overlapping tracks as you open up the door.
   • Full-extension slide tracks, which are often found on 12 in (thirty cm) drawers, most often take straight tabs. Three-quarter-extension slide tracks, which are more mutual on six in (15 cm) box drawers, tend to have curved track levers.

2. 2

   Press downwards on both levers simultaneously. The best way to do this is to use your thumbs or forefingers to disengage the levers while supporting the drawer from the bottom with your remaining fingers. That way, you won't driblet the drawer if it comes off of its rails unexpectedly.^[10]

   • Apply your left hand to press the lever on the lefthand side of the drawer and your right mitt to press the lever on the righthand side of the drawer
   • Some track levers may demand to exist pulled up rather than pushed down. However, this configuration is somewhat rare.

3. 3

   Pull the drawer straight out while holding down the levers. Proceed sliding the drawer towards you, making sure to keep both levers disengaged. When information technology reaches the end of its tracks, it should lift direct out. Remove whatever subsequent drawers from the piece in the aforementioned manner.^[11]

   • When y'all're set up to put the drawer downwards, place it on a flat, sturdy surface.

   Alarm: On some pieces of piece of furniture, the metal retainer tracks will remain extended after you lot've pulled the drawer gratuitous. For your own safety, exist sure to button these tracks back in earlier handing the piece any further.

   Advertisement

1. i

   Slide the drawer out and locate the stabilizer screws at the end of the tracks. Y'all'll observe these screws on the bottom portion of each track. They're used to secure the 2 halves of the rails, the superlative of which doubles equally a catch tab to concord the drawer in place.^[12]

   • If the drawer you lot're attempting to remove has metal tracks just no screws at the end, they may exist metallic glide drawers with levers. See if you can find a pair of track levers to press that will and then let you pull the drawer free.

2. ii

   Use an advisable screwdriver to remove the stabilizer screws. Turn the screws to the left (counterclockwise) to loosen them, then pull them complimentary from the holes in the runway hardware. Set both screws bated somewhere you won't lose them.^[xiii]

   • Most drawers with stabilizer screws use 2 in (5.1 cm) #8 cabinet screws, which need to exist removed with a Phillips screwdriver.^[14]

3. three

   Lift up on the catch tabs to dissever the ii halves of the rail. Pull up on both tabs simultaneously. As you lot practise, the top half of the rails will come up abroad from the lesser one-half, permitting the drawer to open past the stopping mechanism.^[15]

   • There should be enough of a lip on the grab tabs for y'all to hands grip them between your thumb and forefinger.

4. 4

   Pull the drawer out the rest of the manner. Without letting go of the catch tabs, guide the drawer off of its tracks. Hold it as straight as possible and move it in alignment with the tracks to prevent it from sticking. Once it'southward clear, set up information technology downward carefully and move onto the next drawer.^[16]

   • If you're going to be removing multiple drawers, check the lip on the righthand side interior of each drawer for a small number decal. These indicate which drawer goes where, which will brand it much easier to return them all to their proper place.
   • To reinstall a drawer with stabilizer screws, merely work in contrary: align the door with the track, lower the catch tab over the rails'south bottom half, then thread and tighten the screws.^[17]

   Alert: Brace yourself when lifting the drawer out. Drawers with stabilizer screws are likely to be heavy, regardless of how full they are.

   Advertisement

1. 1

   Extend the drawer and expect for the cable on the backside. Pull the drawer out until it stops moving and take a peek at the back panel. There, you should see a pocket-sized metal cable tethering the drawer to the trunk of the piece of piece of furniture. This cable is there to prevent more than one drawer from being opened at the same time.^[eighteen]

   • Anti-tip cables are a common safety feature on top-heavy pieces that are decumbent to losing their stability when multiple drawers are open up.
   • On the top and bottom drawers, the cables will be connected to special inserts attached to the back panel. On the middle drawers, they'll be threaded through eyelets drilled through the back panel.

2. ii

   Disengage the screws holding the cable in identify. There may be one or 2 screws, depending on how the anti-tip hardware is designed, only a pair of screws is most common. Plough the screws to the left (counterclockwise) until they're loose plenty to pull out by manus.^[19]

   • Slip the screws in your pocket or set them on a nearby table or counter to avoid losing them.
   • Different hardware may require different screwdrivers. In most cases, however, a Phillips caput should do the trick.

3. 3

   Press and hold the disconnect tabs if your drawer has them. Examine the rear portion of the metal tracks on either side of the drawer. If yous find a pair of adjustable tabs at that place, press both of them in at the same time to disengage them and allow the drawer to slide freely.^[20]

   • Continue a house grip on the edges of the drawer while you take care of the disconnect tabs.
   • Make sure both tabs are pushed in completely. They may non "lock" into identify on their ain, which ways you'll demand to continue pressing down on them until after you've removed the drawer.

   Tip: In some cases, it may be necessary to push down or pull up on the disconnect tabs (or perform both actions simultaneously) in club to undo them.^[21]

4. 4

   Slide the drawer straight off of its tracks. Pull the drawer towards you until it comes away from the piece of piece of furniture. Yous may need to lift or angle the drawer upwards slightly in order to become it clear of the terminate of the tracks.^[22]

   • Don't forget to push the extended metal tracks back into the piece earlier removing the side by side drawer or going about your business.

   Advertisement

Add together New Question

• Question

  Tin can I purchase the plastic gliders that attach to the drawer?

  

  Yes, you tin can buy them online or look for them in your local hardware or furniture stores.

• Question

  The drawers on my dresser accept no visible rail and very little movement up or down. Can y'all suggest an alternative method?

  

  I accept an quondam Bombay Company dresser and I institute that it had a peg in the back on both sides that needed to be pushed in. This may be the instance for your dresser as well.

• Question

  How can I remove drawers from Nolte furniture?

  

  Pull out the drawer to its fullest extent. Hold the drawer front end with both hands and give a precipitous elevator upwardly. The drawer will detach from the slides and tin can so be removed. To replace, fit the drawer onto the slides and push all the way in. Test correct functioning by pulling out while supporting the drawer to brand sure it halts on the stops.

• Question

  How do I supercede the drawer afterwards it has come up out?

  

  Merely lock information technology back in identify past riding it on the within wheels of the supporters. If the drawer is lacking, measure out the drawer and find the model number for it to look for a replacement in places like Lowes or Domicile Depot.

• Question

  What tin I practice to fix a sliding drawer that has popped off its track?

  

  Line upwardly the drawer with the rails, cheque to run across if information technology's lined upwardly, and push forward.

• Question

  How do I remove a drawer that has a bottom track and a block on it?

  

  Endeavour using a putty knife to pry information technology. Pull it out every bit far equally it will go, then slide the putty knife underneath.

• Question

  How practise I put the drawers dorsum?

  

  If y'all have the ball bearing gliders, there are levers on the sides of the drawers. Squeeze the levers and line the drawer upward carefully. In one case y'all outset sliding the drawers back in, you lot will feel the levers click in place. Then, the drawers should easily glide for you!

• Question

  What do I practise if my draws only go iii/iv of the manner and finish?

  

  If y'all have the ball bearing gliders and they are installed properly, including that they are the correct size, they should glide all the manner out. There are levers on each side that y'all squeeze and they will come out; unless they are worn out. Mine simply opened an inch and I was able to pry them with a flathead screwdriver. The main thing that you demand to be careful of when replacing them, is that they are lined upward properly and level.

• Question

  How do you remove drawer glides if they are mounted at the center of the drawer?

  

  Later it stops when fully open, agree both sides, caryatid knees or pes against dresser and pull with firm, steady pressure on the drawer. It should slide right out. The glides are then accessible and can be screwed off.

Ask a Question

200 characters left

Include your email address to become a bulletin when this question is answered.

Submit

Advertisement

• When removing multiple drawers from a article of furniture, ever beginning with the acme drawer and work your way downward to forestall the piece from tipping over.

• Emptying the drawer of its contents before pulling information technology out will make information technology lighter and therefore easier to hold onto and maneuver. It will also reduce your hazard of injury if you happen to driblet it.

Advertising

• Consider pulling on a pair of thick piece of work gloves when working with metal drawers and tracks to protect yourself from cuts, pinches, and precipitous edges.

• Lightweight drawers can ordinarily be handled safely past i person. If yous plan on taking the drawers out of a loaded filing cabinet or other heavy-duty slice, it's a good idea to recruit an assistant.

Advertizing

Things You'll Need

• Screwdriver
• Thick work gloves (optional)

Most This Commodity

Commodity Summary Ten

If you want to remove forest-glide or free-rolling drawers from a article of furniture, start by pulling the start drawer out as far equally it will go. So, push down on the sides of the drawer so that the back end lifts up slightly. This causes the wheels or lip on the back edge to enhance up higher than the stopper at the forepart of the track. One time the wheels or back edge are past the stopper, you lot tin can slide the drawer off of the track and out of the piece of furniture. Gear up the drawer aside on a flat, stable surface and repeat the process for any additional drawers yous wish to remove! For tips on how to remove drawers with stabilizer screws or metal gliders, read on!

Did this summary help you?

Thank you to all authors for creating a page that has been read 461,693 times.

Did this article assistance yous?

Source: https://www.wikihow.com/Remove-Drawers

Posted by: franklinthavies.blogspot.com

Share this post